The board size 19.6*17.7*2.2 in. (500*450*55mm)
Wood: walnut, maple, osage orange, dark cherry.

How to find inlay parameters.
[ Ссылка ]

Feed rate v bit 30ipm [ Ссылка ] 👍👍👍
Feed rate flat nose 1/8 40ipm [ Ссылка ] 👍👍👍

For orders go to [ Ссылка ]
Check out our Instagram page [ Ссылка ]
[ Ссылка ]


🔥🔥🔥Here some stuff which I use in my workshop and really love it.
Maybe it will be useful for you.🔥🔥🔥

Definitely recommend this Oil and Wax for cutting board:
[ Ссылка ]
[ Ссылка ]

My glue:
[ Ссылка ] (really love it)

Double-Sided Duct Tape:👍👍👍
[ Ссылка ] (It holds blank well, but anyway, I also use screws.)

My Random Orbit Sanders I love how they work but they get a little dusty:
[ Ссылка ]
[ Ссылка ]
Makita 3/4-Inch ID/1-OD diameter by 10-Foot Hose
[ Ссылка ]

My Sanding Disc (for me they are the best!!!):
3M Cubitron II
[ Ссылка ] (80 and 120 grit)
[ Ссылка ] (150 grit)
[ Ссылка ] (220 grit)
[ Ссылка ] (320 grit)

My router bits which I use a lot:
My favorite router bit!!!:
Metric CNC 2D and 3D Carving 6.2 Deg Tapered Angle Ball Nose (clean cut, long life, definitely recommend) 👍👍👍
[ Ссылка ]

2D & 3D Carving 12.4 Deg Tapered Angle Ball Tip x 1/32 Dia x 1/64
[ Ссылка ] (clean cut, long life, definitely recommend)

Standard Spiral Bit with Down Cut 1/8-Inch Cutting Diameter
[ Ссылка ]

15 Degree v bit (be careful easy to break down)
[ Ссылка ]

Round Nose Bit with 3/8-Inch Radius, 3/4-Inch Cutting Diameter and 1-1/4-Inch Cutting Length
[ Ссылка ] (I use it for juice groove)

1/2-Inch Dia. 2 Flute Ball Nose Spiral End Mill Router Bit
[ Ссылка ] (I use it for juice groove)

Spiral Flush Trim Bit with Down Cut and 1/2-Inch Cutting Diameter
[ Ссылка ]

Three Flute with Spiral Bit 1/2-Inch Cutting Diameter and 2-Inch Cutting Length
[ Ссылка ] (I use it for flatining surface and makining cutting board shape)

Spiral Bit with Up Cut 1/4-Inch Cutting Diameter and 1-Inch Cutting Length
[ Ссылка ] (I use it for cut off inlays. it doesn't make chips.)

My Collet Set:
[ Ссылка ]

My DEWALT Plate Joiner:
[ Ссылка ] (it is not bad and not good it is ok)

My Bandsaw Blade it is inexpensive and cut well:
[ Ссылка ]

Hi,
My name is Nik. Welcome to my channel!
I appreciate your likes and subscriptions!

Sincerely,
Nik.

свернуть