----------
Support TheCarPassionChannel on Patreon!
[ Ссылка ]
Want to make a one-time donation? You can buy me a gallon of E85!
[ Ссылка ]
Interested in having a 1 on 1 video call? Details below:
[ Ссылка ]
What’s that digital gauge in the dash?! It’s called a CanChecked and you can pick one up from my friends at Bofi Racing!
[ Ссылка ] (Car Passion affiliate link)
Check out my Amazon Store!
[ Ссылка ]
Use coupon code CARPASSION50 to save $50 on your first High Performance Academy course!
[ Ссылка ]
---------
More Info About The Build: (Quantities are to replicate mine)
48" x 48" x 0.187" ABS Plastic Sheet (1 needed):
[ Ссылка ]
100-Pack of #10-24 Machine Screws (70 needed):
[ Ссылка ]
100-Pack of #10-24 Nylon Lock Nuts (70 Needed):
[ Ссылка ]
50-Pack of L Brackets (35 needed):
[ Ссылка ]
2-Pack of Splitter Rods (2 needed):
[ Ссылка ]
1-Pack of DEI 12" x 24" Heat Tape Sheet (1 Needed):
[ Ссылка ]
1-Pack of Black RTV (Less than 1 tube needed)
[ Ссылка ]
The following pieces are exactly the dimensions of the parts used in this build, but it's hard to find small quantities online. It will be much better to source them locally from a hardware store, or shop around online for similar products in smaller quantities. Total cost for everything below, in the quantities used, was about $11.00.
1" x 0.125" Aluminum Flat Bar, Yes I said steel in the video SORRY (12" Needed)
[ Ссылка ]
#12-24 Machine Screws (2 Needed, Rear Bracket-to-Splitter)
[ Ссылка ]
#12-24 Nylon Lock Nuts (2 Needed, Rear Bracket-to-Splitter)
[ Ссылка ]
#12 Flat Washers (4 Needed, Rear Bracket-to-Splitter)
[ Ссылка ]
1/4" x 28tpi x 1" Hex Bolts (2 Needed, Rear Bracket-to-Car)
[ Ссылка ]
1/4" x 28tpi Nylon Lock Nuts (2 Needed, Rear Bracket-to-Car)
[ Ссылка ]
1/8" Drill bit was used to drill for the #10-24 screws threaded into the ABS
Standard AND Metric Screw Size vs Tap Drill Size Chart:
[ Ссылка ]
Matt's Instagram
[ Ссылка ]
[ Ссылка ]
All amazon links above are affiliate links
