The ARGB Cable Kit lets you take control of more LIAN LI ARGB products either via the Uni Hub or via synchronization with the motherboard.

Supports: Strimer/ Strimer Plus/ Galahad AIO/ ST120/ Bora Digital/ LANCOOL II Side Diffused LED Strip/ O11D XL light bar/ DK-04F&05F light bar

---------------------------------------------------------------------
This tutorial is a handy step by step clip that you can learn how to control the fan speed and light mode of Galahad AIO/ Strimer/ LANCOOL II-2X (light bar)/ RGB fan of LANCOOL II MESH on L-Connect

Kits:
→ Light Bar Extension Cable(3P)
→ Y-type 3P Signal Cable
→ Fan LED Extension Cable (4P)
→ 2×Fan Y Cable
→ Uni Hub

Steps:
Step 1. Connect Strimer 24 pin/ 8 pin, one UNI FAN and Galahad AIO Water Block to Uni Hub by Light Bar Extension Cable/ 3P
Step 2. Connect the PWM cable of UNI FAN to UNIHUB.
Step 3. Recommend to connect the PWM cable of the GALAHAD AIO water block to the MB directly.
Step 4. Group UNI FAN, screw to Galahad AIO and connect to UNI HUB
Step 5. Connect the LANCOOL II-2X (Side Diffused LEDs Strip) to Uni Hub with Y-type 3P Signal Cable.
Step 6. Remove the original cable that connects to the I/O port of LANCOOL II MESH RGB fans and connect them to UNI HUB by Fan LED Extension Cable (4P).
Step 7. Daisy chain the 2 Fan Y Cable and connect the 3 RGB fans to UNI HUB .

Note:
Each group of UNI HUB ARGB output supports a maximum of 100 pcs LED.
The C and M buttons on the I/O port would not function in this scenario.

Shop Now ▶
[ Ссылка ]

свернуть