So you're ready to try PETG? I needed the thermal strength of PETG over PLA, so I went through a set of calibration prints and I'll take you through what you need to do on any printer to get successful prints.

PETG on Amazon: [ Ссылка ]
Anycubic Mega S: [ Ссылка ]

I am using the Anycubic Mega S printer with stock hotend and print bed, so if I can do get successful prints you should too! The biggest issue I battled for a few days was a bad nozzle. Replace your nozzle if you haven't in a while.

I am now getting similar print quality to PLA prints, so I think that is a well calibrated system.

The gear I use:

Main Camera: [ Ссылка ]
Perfect Prime Lens: [ Ссылка ]
Sharpest Wide Lens: [ Ссылка ]
Telephoto Nikon Beast: [ Ссылка ]
Favorite Not RODE Mic: [ Ссылка ]
Best Portable Vlog Mic: [ Ссылка ]
Perfectly Smooth Gimbal: [ Ссылка ]
Camera Strap: [ Ссылка ]
Atomos Ninja V Recorder: [ Ссылка ]
Affordable Studio Light: [ Ссылка ]
Drone: [ Ссылка ]
Perfect Camera Bag: [ Ссылка ]

💼 Business Inquires : goattoaster9@gmail.com

свернуть