Here is the process for resurfacing the spoil board on a Biesse Rover 24 with a 4' X 10' vacuum table. I use a 75mm surfacing tool. I will show you how to set the spoil board thickness and how to resurface it with one pass. In this video I show taking 2.5 mm off the spoil board.
In general I run bits only .002 below the bottom of material. Most times we can go months without having to resurface the spoil board. But in this case I had two issues. One is that I am training a person to write code and he set the tool depth too low. Also, I started cutting plastic (acrylic) with a 1/2" O-Flute bit and didn't have the tool holder set right.
Anyhow...it is a perfect opportunity to show you guys and gals how to resurface the spoil board!
Please like the video and share it with anyone you think might benefit from it!
Be sure to visit my website at [ Ссылка ] where we are building a community of Biesse programmers and operators along with all people from the tech community! All are welcome! Be sure to register and become a member! Write articles and share ideas!
Be well!
Lee -
~ Please consider becoming a patron. These videos are made on my personal time and I do them with the spirit that if I have struggled with learning a machine or a program, then others probably have had the same struggles. I'm blessed with tenacity and don't stop until I find answers...which leads to figuring out difficult processes. If these videos help, then my purpose in life is being fulfilled. Thank you for watching and reading to this point. Support at any level is greatly appreciated!
[ Ссылка ]
Ещё видео!