Have you been holding off on unboxing your Monport K40 laser engraver/cutter because setting it up seems daunting? Well, connecting it to Lightburn and getting engraving takes just a few minutes! In this video, we'll break down the software-side connection, testing, and doing your first material test to ensure everything is working properly.
~~~~~~~~~~~~~~~~Chapters~~~~~~~~~~~~~~~~
00:00 - Intro
2:53 Laser Overview
4:27 Lightburn Connection
7:27 Lightburn Material Test
10:50 Material Test Results
12:07 Outro
~~~~~~~~~~~~~~~~Links~~~~~~~~~~~~~~~~
Use code CREATEDWORKSHOP10 for 10% off at Monport
Monport K40 with Lightburn [ Ссылка ]
Calipers - [ Ссылка ]
Exhaust fan kit - [ Ссылка ]
6-inch Duct Hose [ Ссылка ]
6-inch to 4-inch Reducer [ Ссылка ]
18-gauge Wire for Z Axis [ Ссылка ]
JST Connectors for Z Axis [ Ссылка ]
Motorized Z Axis [ Ссылка ]
Cloudray Laser Head with Air Assist for K40 [ Ссылка ]
110L/min Air Pump [ Ссылка ]
Lightburn - [ Ссылка ]
Creative Fabrica - [ Ссылка ]

~~~~~~~~~~~~~~~~Camera gear~~~~~~~~~~~~~~~~
Body: Sony a6500 [ Ссылка ]
Body 2: Sony a6000 [ Ссылка ]
Main lens: Sony 18-105mm f/4 [ Ссылка ]
Secondary lens: Tamron 28-75 f/2.8 [ Ссылка ]

~~~~~~~~~~~~~~~~Merch~~~~~~~~~~~~~~~~
Check out my merch store to support Created Workshop! [ Ссылка ]

~~~~~~~~~~~~~~~~Social links~~~~~~~~~~~~~~~~
Be sure to follow me across social media to stay up-to-date on the latest projects at Created Workshop!
[ Ссылка ]
[ Ссылка ]
[ Ссылка ]

~~~~~~~~~~~~~~~~Affiliate disclosure~~~~~~~~~~~~~~~~
Some of the links above are affiliate links and Created Workshop could earn a small percentage of revenue from your purchase through them. There is no additional charge for you to use these links, but it does go a long way to support our content.

свернуть