We can make molds of any size.

To buy our HDPE Molds Visit:
[ Ссылка ]

To buy our Kiln Dried Olive Wood Visit:
[ Ссылка ]

Epoxy Resin tables are made much easier using a HDPE reusable Mold.
HDPE plastic molds are the perfect material for non-stick molds used for resin projects. Its non-adhesive quality does away with the need to use any kind of release spray or duct tape. Furthermore, the molds are completely reusable.

Multi Purpose HDPE Mold!

We can make molds of all sizes!

All Molds are made with 12mm (1/2″) HDPE. The sides are 7cm (2.75″) high.

You can make different projects at the same time with this multi purpose HDPE mold . The configuration of the inserts are completely changeable. All that is required is to silicon the internal sides of the mold.

To see how to clean our HDPE molds go to [ Ссылка ] (time line 16:16)

HDPE plastic is the perfect material for non-stick molds used for resin projects. Its non-adhesive quality does away with the need to use any kind of release spray or duct tape. Furthermore, the molds are completely reusable. With a potentially infinite number of times that the mold can be reused.



Are you sick of:

a) the time it takes having to make a different mold for every project,

b) having your mold stick to your project when it comes the time to remove it or

c) having to tape your mold prior to pouring the resin, then a HDPE mold is definitely for you.

One of the points to consider when choosing a HDPE mold is that the thickness of the HDPE is often overlooked. HDPE is an expensive material however only the surface of the HDPE comes into contact with the resin.

Consequently, there is little point in going to the expense of purchasing very thick HDPE molds, when really all that you need is the HDPE surface.
At rivertables.es all of our projects are made using these molds!

We are also able to sell our molds much cheaper than our competitors as we have done away with unnecessary extras. Small bubble spirit levels are notoriously unreliable, particularly when attached to the removable sides of the mold.
You should place the mold on a sturdy flat surface, this flat surface should then be levelled using a long spirit level. This will then negate the requirement for adjustable feet.

All the sides of our HDPE molds are 7cm high. Machined cut to size and secured with threaded inserts and bolts which allow for easy assembly and de-molding. Plus, the sides are straight, not tapered like some of the welded HDPE molds on the market, leading to less wasted resin and less finishing work. You can construct the mold in under a couple of minutes.
As is the case with the majority of molds the only additional requirement is the sealing of the edges with a standard silicon.

If you would like a size which is not listed, please contact us! We are able to make molds on any size.

SEE HOW OUR MOLDS ARE MADE VISIT
[ Ссылка ]

свернуть