I've been sent the BIQU B1 3D Printer to take a look at so in this video I Unbox, build and test the machine, and ultimately run a 30 hour print using some very nice Gold PLA filament also sent to me by Enotepad. The printer seems like great value for money and is currently around £200 or $250.

You can purchase the BIQU B1 Printer here:
[ Ссылка ]

The filament is available here
GOLD: [ Ссылка ]
BLACK: [ Ссылка ]

Merlin Firmware Update
To complete the firmware upgrade I copied the firmware.bin file to the root directory of an SD card and inserted it to the rear SD card slot, then powered up the machine and waited for the update to complete. File available here: [ Ссылка ]

Screen Firmware Update:
To complete the screen firmware update I copied the following files to the root directory of an SD:
TFT35 (directory)
BIGTREE_TFT35_V3.0_E3.26.x.bin
config.ini
Insert the card into the front SD card slot, then powered up the machine and waited for the update to complete. Files available here: [ Ссылка ]

Support my channel:

I now have a store front on Amazon with tools and materials I use in my projects:
[ Ссылка ]

The original 5 X Scale Giant Go-Kart files and other 3D printable giant lego projects are available to purchase here: [ Ссылка ]

00:00 Introduction
00:40 Unboxing
02:18 Build
04:27 Build Notes
06:10 Switch On & Setup
07:38 Initial Test Print
08:05 First Print Review
10:10 Different Modes & SD ports
11:04 Marlin Mode
11:50 BIQU Mode
13:23 Filament Sensor Test
16:35 Resume From Power Fail Test
18:36 My Conclusion
20:03 30 Hour Test Print

свернуть