Complete W56 transmission rebuild and repair in my residential garage! Installing a brand new bearing, seal, and gasket kit to completely refresh and repair this transmission from my 1987 Toyota 4Runner. Ever wondered how a manual transmission works/operates? Take one apart!
Previously it blew an input shaft bearing so I went through the entire transmission, tore it apart, cleaned up all the metal shavings, removed everything, and now I'm putting it back together and guess what...IT WORKS!
The W56 was found in the Toyota 4Runner and Pickup from 1985 - 1995, both 2WD and 4WD models. Should also apply to other Toyota Transmissions including W55, W56-A, W56-B, W56-C, W56-D, W56-E, W57, W58, and W59. This transmission is found in the Toyota Pickup and 4Runner, but should also apply to later Tacoma and T100 models using the W59 and Celica, Cressida which also use a similar transmission.
Previously I tore the entire transmission down and completely disassembled it. You can check out the last videos below!
Previous videos in this series:
► Taking cases apart: [ Ссылка ]
► Removing transmission: [ Ссылка ]
► Complete Disassembly (part 1): [ Ссылка ]
Follow me on Instagram!
► [ Ссылка ]
*Camera Equipment Used in This Video!:*
Sony ZV1 Camera: [ Ссылка ]
Rode Microphone: [ Ссылка ]
Lens: [ Ссылка ]
Tripod: [ Ссылка ]
Link to rebuild kit:
[ Ссылка ]
0:00 Intro and recap
0:38 Clutch Hubs and Sliders
3:20 Installing 2nd Gear, Synchros, Bearings
6:47 Installing 1st Gear, Synchro, Bearings
11:10 Input Shaft Bearing Replacement
12:10 3rd Gear, Synchro, and Clutch Hub Installation
15:30 Main Shaft Complete, Installing New Bearings on the Cluster Shaft
18:20 Installing Input Gear, 4th Gear, and Synchro Ring
20:20 Installing Shafts Into Intermediate Plate and Snap Rings
21:50 Installing Rear Bearing Retainer
22:42 Installing Reverse and 5th Gear (with some heat)
24:15 Big Mistake...Destroyed a Brand New Bearing!!!
25:35 5th Gear, Clutch Hub and Slider, Bearings, Synchro Install
31:42 Installing All Shift Rails, Forks, Interlocks
42:25 Detent Balls, Springs, and Plugs
43:51 Replacing the Output Shaft Seal and Inner Race
45:50 Installing the Transmission Cases (The final stretch!!)
48:29 Front Bearing Retainer, Seal, and Snap Rings
49:40 Will it Shift? Testing the Transmission
51:00 DONE! Outro
Huge thanks to @austinniemela and @GearBoxVideo for their content which helped me rebuild this transmission.
#transmission #rebuild #repair #rmgarage
