Finally in this last video of the series on the complete build of the Dissent Off-Road No Cut Modular Rear Bumper for the Landcruisers 100 series and Lexus LX 470, I finish assembling the swing arms and give a lot of details and some great time saving tips on the entire process. I also mount the tire carrier and jerry can holder accessories onto each swing arms and finally do a big reveal of the completed bumper.
The bumper is massively stout and will NOT disappoint you. Ben, the owner of Dissent Off-Road and his team do an amazing job at putting out a fantastic product, hand built right here in the USA and with an attention to details that will amaze you.
I chose the all steel bumper however some parts of the accessories are made of top grade aluminum for weight saving. The black powder coating is equally impressive and the entire bumper and accessories arrived extremely well packed without a single scratch.
My options for this bumper were
- Rear base bumper (steel)
- Tire carrier with aluminum riser and flip up table
- Basket and tray accessory mount (require for the jerry can holder) include the secondary hitch receiver for mounting bike racks!
- 3 Jerry can basket
- Accessory swing arms (needed if you want 2 swing arms)
- Hi-lift mount
Chapters in the Video
0:00 - Intro
00:46 - Swing arm - Latching Mechanism Assembly
09:21 - Swing arm - Spindle and Spindle Bearing Assembly (important items discussed in this chapter)
13:33 - Swing arm - Packing the bearings with grease
14:05 - Swing arm - Sanding / cleaning the spindle housing from powder coating residue/ (important step to improve the installation of the bearing dust seal!)
16:54 - Swing arm - Pressing the bearing dust seals into the spindle housing. DELICATE operation.
19:27 - Swing arm - Reassembling the spindle with the bracket ready to mount on the truck
19:59 - Swing arm - Attaching the swing out to the bumper (******** IMPORTANT THE 4 7/16th Bolts that are used to secure the swingouts to the base bumper must be torqued to 52 ft/lb and NOT 95 ft/lb. Ben sent me a correction for his install instructions, unfortunately I cannot edit the video without losing my view counts *********)
24:57 - Swing arm - Installing the gas strut
28:22 - Swing arm - Roscoe my dog comes to say Hi and make sure all is going well :-)
30:17 - Swing arm - Adding the bump stops
35:45 - Swing arm - A closer look and demonstration of the great latching mechanism
38:58 - Swing arm - License plate relocation bracket
39:48 - Swing arm - Mounting the Jerry can holder basket onto the passenger side swing arm
43:16 - Swing arm - Mounting the tire carrier onto the driver side swing arm
43:56 - Swing arm - Tire carrier arm adjustment (important info there)
51:03 - Swing arm - Hi-Lift jack adjustment for proper fit.
53:07 - THE BUMPER IS DONE - THE BIG REVEAL !
Complete bumper weight is roughly 260lbs (dry i.e. not with the wheel and jack on the bumper)
And if you're thinking about getting a rear bumper for your LX470 or Landcruiser 100, please give Ben a call and tell him Sam sent you! [ Ссылка ]
--------------- IMPORTANT THINGS TO REMEMBER -----------------
** If you have a topic you want me to make a video about use #deepsouthoverlander in the comments. **
If you have any questions, comments or suggestions about my channel or the topics I cover, please leave them in the comments. !!
Ещё видео!