In this video, I design the wasteboard for the Onefinity CNC in Fusion 360.
The wasteboard design is super simple. I used 1/4 threaded T-nut inserts on the bottom side of the board so it's easy to clamp things down. After finishing the design I then used the Onefinity CNC to cut out the holes for the T-nut. The board is then flipped over, secured to the table, and level cut with a 1-inch surfacing bit. This project should have been much easier but I managed to make numerous mistakes. Eventually, the wasteboard got completed and I am really to move on.
If you are looking for step-by-step instruction for setting up your Onefinity CNC. Here is a link to the factory setup guide. [ Ссылка ]
If you're interested in any of the aquarium-related models please leave a comment and check out [ Ссылка ].
If you would like me to create something specifically for your nano reef aquarium, please join the conversation here...
[ Ссылка ], or leave a comment about what you would like me to make next.
Thanks, Mark
![](https://i.ytimg.com/vi/QcOmCu9bY0I/maxresdefault.jpg)