Here is a look at how to program your Display.

If you have a KT Controller, which is one of the most common in the ebike world, then you probably have seen these displays. They have a host of different parameters that can be programmed right from the display.

Cheat Sheet is at the beginning and end of the video but here are the parameters;

P SETTINGS
P1 = Magnets
P2 = speed sensor pulses per revolution (6 for Bafang , 1 for most)

P3 = 0 throttle is limited by gears, if 1 throttle is always full power available

P4 = 0 throttle always works, 1 throttle works only when pedalling

P5 = Battery Display – 36V = 12 , 48V = 15 , 52V = 22 , 0 for real-time voltage

C SETTINGS

C1 = 2 for Basic, 7 for Splined (KT-V12L) / 2pc Disc (KT-D12L)

C2 = Generally set to 0 (Motor phase)

C3 = Pedal Assist Level when you first turn on the bike
0 = defaults at 0
1 = defaults to 1, etc
8 = defaults to last setting before power down

C4 = 0 Throttle always working
1 Throttle by itself only 6km/hr

C5 = Current Control 10 for highest, 3 for lowest, 0 for soft start

C6 = Backlight adjustment

C7 = Cruise Control 0 is off, 1 is on, works by holding Up

C8 = Motor Temperature (if available)

C9 = Password

C10 = Return to defaults

C11 = Communication Protocol (restoring another display)

C12 = Low Voltage Cutoff (default 4) lower the number, lower the voltage cutoff

C13 = Regenerative Braking 0-5

C14 = Pedal Assist Overall Multiplier


Questions? Reach out! AffordableEBikes@gmail.com
www.AffordableEBikes.ca

Thanks for watching!

свернуть