You just set up your new 3d printer. This video will help you print your first model downloaded from the web.

It begins by explaining how to install Cura on your computer and configure your printer. Then I show you how to download a model from Thingiverse followed by instructions about slicing the model. Finally, I show the steps to print from an SD card.

Let's continue to learn things together.
Irv

---
The following links are to products I have used, reviewed, or evaluated for the MakeWithTech community. Some of the links below are affiliate links that provide commissions, at no cost to you, and help support the MakeWithTech video production, purchase of products for reviews, lab, forum, and web site.

I have reviewed the following printers or similar printers:

➡︎ [ Ссылка ]

These are some of the tools I use for 3d printing day-to-day:

➡︎ [ Ссылка ]

I have reviewed or used the following 3d printer upgrades:

➡︎ [ Ссылка ]

Here are the 3d printer filaments I use to evaluate prints, software, and techniques:

➡︎ [ Ссылка ]

I will be covering basic electronics and software in future MakeWithTech segments and here are the products I am using:

[ Ссылка ]

Some of the Woodworking products I use:

[ Ссылка ]

---
** Affiliate disclaimer: some of the above links in my videos may be affiliate links, which generate a sales commission for me. Your price is the same or less than if you go to the site directly. These sales commissions help to support the MakeWithTech channel. ([ Ссылка ])

** MakeWithTech and the MakeWithTech videos are Copyright Cogitations, LLC. ([ Ссылка ])
** Equipment used in the MakeWithTech videos has the potential to cause injury if misused. Use all equipment and tools at your own risk and follow all manufacturer's safety recommendations.

** Cogitations, LLC licenses all music used in the MakeWithTech videos from Epidemic Sound. Cogitations, LLC uses only authorized or open source clip art and third party images. Images .

свернуть