Full detailed tutorial:

[ Ссылка ]

In this Video you showed you a complete walkthrough of a Bitmain Antminer initial setup with Antpool!

we will explain step by step the meaning and content of the entire interface of a Bitmain Antminer.

If you struggle to get your miner working you can always contact us!

As the proud owner of a Bitmain cryptominer, you can look forward to a very simple setup. In the tutorial below, we will explain how to log in to Antpool and get your miner up and running.

The Antminer consists of a housing with the ASIC modules and a controller board with LAN connection. The power connectors of the ASIC modules protrude from the housing and are connected to the controller board. The housing forms an elongated air duct with a fan on the front and a fan on the back. This pulls cool air in a stream through the case and ensures adequate cooling

When connecting the power supply, make sure that the cables are plugged in the correct direction. For this, each connector and cable has a clip, this clip should snap once in place.

For larger miners with more ASIC boards and multiple power supplies, there is a bit more to consider. For example, connecting different power supplies on the same ASIC board is not recommended and may damage the hardware. Therefore always connect only the power cables from one power supply to one ASIC module.

After all cables of the power supply have been connected to the ASIC modules and the controller board, the miner can also be connected to a router or switch and then to the power supply. Once the power cable is plugged in, the miner will automatically boot, running the fans at maximum speed.

Last but not least, we have summarized the entire web interface in a short video.

свернуть