In This Video we will see step by step procedure how to do manual zero calibration for AO 2000 Model
The zero should be calibrated manually prior to a manual span calibration.
Test Gas Supply If the test gases enter at the zero or span gas input, the test gas supply is
controlled by the integral valves.
If the test gas enters directly via the sample gas inlet, the zero and span gases
must be blocked off.
It may be necessary to repeat calibration if the measurement value is still not
stable after calibration has been started. The subsequent process is based
on the measurement value obtained in the previous calibration.
Stay connected with our social media pages:
Website : [ Ссылка ]
Instagram : [ Ссылка ]
twitter : [ Ссылка ]
LinkedIn : [ Ссылка ]
Telegram : [ Ссылка ]
Facebook page : [ Ссылка ]
Blog : [ Ссылка ]
Pinterest : [ Ссылка ]
FAIR-USE COPYRIGHT DISCLAIMER:
We have uploaded this videos with the intention to educate others in motivational/inspirational and non-commercial form. we may not own certain contents and music, we use in most cases.
Our understanding is that it is in correlation to Fair Right Use,
however given that it is open to interpretation, all credits go to its rightful owner. If any owners of the content clips would like us to remove the video, we shall immediately remove the content. This oversight will not happen in the future. If any content is incorrect or misleading kindly Contact us.
kannan@analyzerinstruments.com
