Why doesn't everyone make one of these? This is an inexpensive Moxon Vise Build.
I was tired of jerry-rigging clamps as a vise, but I didn't want to spend a lot of money on one. So, I did some research and came up with a simple diy option that I think ANYONE can build in a day or two. I also created some free plans for this one which you can get at [ Ссылка ]
There are lots of videos to come, so be sure to subscribe!
Help me out by purchasing my recommended products with my affiliate links:
My favourite mechanical pencil (Graphgear 0.9mm): [ Ссылка ]
Pica Dry Pencil: [ Ссылка ]
My bandsaw fence: [ Ссылка ]
My Kreg pocket hole jig: [ Ссылка ]
My favourite mitre gauge (Incra 1000SE): [ Ссылка ]
My Makita Mitre Saw: [ Ссылка ]
My Dewalt router (plunge and fixed base): [ Ссылка ]
My Dewalt cordless palm router: [ Ссылка ]
Dewalt Budget Thickness Planer: [ Ссылка ]
Suizan Japanese Ryoba Pull Saw: [ Ссылка ]
Suizan Japanese Dozuki Dovetail Saw: [ Ссылка ]
Suizan Japanese flush cut saw: [ Ссылка ]
Electric palm sander: [ Ссылка ]
My favourite impact driver: [ Ссылка ]
My favourite tape measure: [ Ссылка ]
My favourite glue bottle: [ Ссылка ]
A great drill/driver starter combo kit: [ Ссылка ]
My favourite chisels: [ Ссылка ]
Good Toggle Clamps: [ Ссылка ]
Microjig Matchfit System: [ Ссылка ]
My 3D Printer: [ Ссылка ]
My 3D Printing Filament of Choice: [ Ссылка ]
___
If you're looking for a church, reach out to my church: www.abundantsprings.church. We've got a great online and local service, and would be happy to connect you with a church in your area!
00:00 Introduction
01:26 Free Plans
01:49 The Build
07:59 Facing the Jaws
10:02 Threaded Knobs
12:01 Moxon vise storage
![](https://i.ytimg.com/vi/S16nnj4241E/maxresdefault.jpg)