THE MATERIAL LIST IS BELOW

Using a drill battery to upgrade your child's Power Wheels is fun, but if you aren't using a Low Voltage Cutoff protection, it can be dangerous for the battery and your child.

The video showed a Low Voltage Cut Off of 14.5 and a Reset rate of 4.5, on a 18/20V use 16.0 volts as a cut off and 1.0 for the Reset.

Low Voltage Cut Disconnect rates:
12 Volt battery: set the cut off between 9.0 and 9.9 / Reset Rate: @9.0 cutoff use 1.0, @9.9 cut off use 1.0 (Recommended 9.9 volts; Reset 1.0)

18 & 20 Volt battery: Recommended cutoff is 16.0 volts; 1.0 Reset

MATERIAL LIST:

Below are the items and links to the products I have used in the video. Note, as an Amazon Associate member, I earn from qualifying purchases. If you purchase through Amazon, you can help support this channel just by purchasing through the links.
24v relay (with wire connectors, so you wont need to drill a holes) [ Ссылка ]

Low Voltage Cutoff Board:
[ Ссылка ]

12 Gauge Wire: [ Ссылка ]

20 Volt Battery (your choice of course): [ Ссылка ]

Battery Charger: [ Ссылка ]

Wire Connection Kit: [ Ссылка ]

Terminal Block: [ Ссылка ]

12 Gauge In-Line Fuse: [ Ссылка ]

You will also need a Wire Stripping tool ( [ Ссылка ] ) and Wire Crimping tool ([ Ссылка ] )

свернуть