In todays episode I sealed in the rear baffle as well as the fuel pickup and sender in the access plate. The tank is now complete and will be ready for a leak check after it cures for a week or two. I feel good now that its built but I still have to do it all over again on the left tank.
Listed below are my affiliate links to some of the tools you have seen me use on this channel so far. If you are going to buy them anyways then I appreciate the support. Hope you enjoy and leave your questions or comments below.
Silicone Sealant spatulas [ Ссылка ]
C Frame and squeezer yokes [ Ссылка ]
Endoscope [ Ссылка ]
Label printer [ Ссылка ]
Welder [ Ссылка ]
Measuring etc:
Machinist Square [ Ссылка ]
Combination Square [ Ссылка ]
Straight Edge [ Ссылка ]
Angle Finder [ Ссылка ]
Epoxy Resin work:
3M respirator mask [ Ссылка ]
Rubber Gloves [ Ссылка ]
Digital Scale [ Ссылка ]
Mixing cups set [ Ссылка ]
Self Etching Primer [ Ссылка ]
Sanding Block [ Ссылка ]
Rasp [ Ссылка ]
File Set [ Ссылка ]
Sanding Sponges [ Ссылка ]
West Systems Resin kit [ Ссылка ]
Electrical:
Magnifying Lamp [ Ссылка ]
Molex Micro-fit connectors [ Ссылка ]
Cable Snap Bushings [ Ссылка ]
Dupont crimp tool [ Ссылка ]
Helping Hands [ Ссылка ]
Ещё видео!