Hate installing screen protectors? Try the new ONETIME by FLOLAB! This iPhone 14 Pro screen protector has an installer which makes it almost impossible for dust to get caught under the screen protector during the installation process. Plus, it is blue light blocking, antimicrobial, super thin and is made of tough aluminosilicate glass. And like all FLOLAB screen protectors, the ONETIME is backed by FLOLAB's lifetime replacement warranty. Lots to love here from FLOLAB!
00:00 Introduction
00:43 What’s in the box?
01:06 Installation prep
01:18 Separate the two halves of the installer
01:33 Put your phone in the bottom of the installer
01:47 Clean your phone with wet wipe and microfiber cloth
01:56 Put the big dust removal sticker on top of your phone
02:27 Remove the dust removal sticker and put on the top section of the installer
02:44 Pull the tab to expose the adhesive
03:05 Slide your finger down the installer to make things adhere
03:16 Take off the installer
03:48 Results
06:21 Case compatibility
08:02 Pricing, discounts and where to buy
The installation process is reasonably simple, starting with the standard steps of powering down, removing any cases or screen protectors and then placing the phone into the bottom section of the installer. Then, cleaning the phone screen thoroughly with a wet wipe, followed by a microfiber cloth and then by placing an oversized dust removal sticker over the entire screen in order to catch any remaining dust. Following that, once the large dust removal sticker has been removed, the top section of the installer, which has the screen protector preinstalled, is placed over the bottom section which has the phone inside it. Once the top is securely attached, a tab is pulled to remove the plastic covering of the screen protector inside the installer, and then you are supposed to slowly slide your finger down the exterior of the installer to help the screen protector adhere. Then wait 20 minutes, and then remove the top section of the installer and take out your phone. This part is a little trickier than expected, as there is adhesive holding your phone in place, but once your phone is out, all is well. In my case, I had a few small bubbles at the end of the installation process, but they rubbed out easily. And perhaps most importantly, there was zero dust under the screen protector.
Once installed, the ONETIME screen protector was a pleasure to have on the phone. Very thin, nice rounded edges, perfect alignment on all sides, and it fit with all five cases I tried it with: CASETiFY Impact, Apple Silicone, OtterBox Symmetry, RHINOSHIELD SolidSuit, and Mous Limitless 5.0. Optical clarity was excellent, with no blue or yellow tint, the oleophobic coating felt slippery smooth and there were no issues with haptic touch. As to whether the Blue Light Blocking feature really helps, I can't tell, but I imagine it is probably a good thing to have.
The ONETIME for iPhone 14 Pro is available directly from FLOLAB and comes in the Anti Blue Light version featured in this review, as well as a Matte and a Privacy version. All three have the same MSRP of $29.95 and all are currently on sale for $19.95. Plus, you can save an additional 10% by using the affiliate code especially for my viewers: TR10. Many thanks to the kind folks at FLOLAB for sending me out this sample to review.
[ Ссылка ]
****Affiliate coupon: TR10
Thanks so much for watching, and have a wonderful day!
#iphone14pro
Ещё видео!