How simple are our CBS Aluminium Canopies to install?
1. For the Canopy: Mark drill holes for the 3 x canopy brackets (using brackets as a template) at Minimum Height = 2250mm
N.B. When including a side panel, remember to take the ‘offset’ caused by the side panel into account.
2. Detach the LED panel and pull the power cable through the canopy
3.Attach the joint sealing tape to the Aluminium Angle component supplied. Drill holes through from above with a 3.5mm drill bit and insert the screws.
Allow the canopy a 1-2° pitch for water to run to the front.
4.Drill holes through from below with a 3.5mm drill bit and insert the screws.
5.Connect the LED panel to the power cable and reattach it to the canopy.
6 For the side panel: Mark drill holes (using brackets as a template).Drill the holes with a 12mm drill bit.
Insert wall-plugs, then loosely fit the brackets with 2 screws & 2 washers each.
Align the brackets with a spirit level and then tighten the screws.
7. Place the side panel on the brackets.Then slide the side panel up to meet the canopy.
Pre-drill holes with a 3.5 mm drill bit and then insert the screws through the side panel & into the brackets on the inside and outside of the side panel.
8.Finally place a line of silicone sealant between wall and the canopy.
Ещё видео!