In this video we give you detailed instructions on the proper way to place and set up your new Cold Plunge.
INSTALLATION INSTRUCTIONS
1. Remove your Chiller from your plunge and place it to the side.
2. Place the plunge on a flat surface with 16" behind it for equipment access.
(Do not place Plunge within 5 feet of any other appliance!)
3. Place the Chiller in place.
4. Attach the tube from the pump to the chiller.
5. Fill the Plunge with water 4" from the top.
6. Attach the tube from the filter to the chiller.
7. Plug your chiller into the empty outlet in the electrical box.
8. Plug the cord coming from the electrical box into a GFCI outlet.
9. The pump will start and run continuously. It may take a few minutes to prime, but it should get to full speed quickly.
If it doesn't:
1. Unplug the Plunge
2. Unscrew the hose coming from the pump and put it over the edge of
the plunge so water will go into the tub.
3. Plug in the Plunge for 5 seconds.
4. Unplug the plunge.
5. Screw the hose tightly back on to the chiller
6. Plug the Plunge back in.
10. Once your Plunge is powered on, make sure the Chiller is on by flipping the
switch up on the right side of the Chiller then hit the ON button. Note: Only run the chiller when the pump is running. When draining the Plunge, make sure to first unplug your Plunge.
11. Set your temperature by hitting the SET button, push DOWN or UP until the smaller number equals your set temperature, then press SET again.
12. Cover your plunge when not in use to keep debris out and keep it insulated (if you have the insulated cover.)
13. The Plunge is made to run continuously to keep the water clean. To lower electrical usage when away from home, you can simply turn off the chiller. The pump and filtration use very little electricity.
14. Make sure you've read our warnings to make sure you are kept safe.
The Plunge will cool down in the range of 2.5 degree an hour, so you'll be
Plunging in chilly water tomorrow morning!
For more information, check out [ Ссылка ]
Ещё видео!