Dry Filament = No Stringing
This filament has been open for several months so it was quite wet. We printed a benchy, and there was A LOT of stringing. We dried it in a filament dryer for 6 hours, used the same printer and settings and there was minimal stringing.
Check out the Micro Center Maker Community: [ Ссылка ]
Shop 3D Printers: [ Ссылка ]
Shop filament and resin: [ Ссылка ]
Amazon Storefront: [ Ссылка ]
Instagram: [ Ссылка ]
Facebook: [ Ссылка ]
Twitter: [ Ссылка ]
TikTok: [ Ссылка ]
Printables: [ Ссылка ]
Ещё видео!