I have another video on how to disassemble the same rack. Here is the link:
[ Ссылка ]
This video shows how I went about rebuilding the rack on a Triumph Stag. The rack is assembled and in the car. It is working and I will monitor the cheaper rack seals I used.
Here is an update. March 2021. The cheaper seals leaked. I think the walls of the seals were too thin to keep the fluid in. However, on disassembly they looked OK. .Again I ran into a problem with the seal at the top of the control valve. I took a slice out of the seal. The end of the shaft should have been chamfered so the seal can slide over it. I did find another old shaft and the end of that shaft was chamfered so it looks like a design change.
If you need a manual for the rack, it can be found here: I'm not the owner of this site. and I would like to thank the person who posted it.

[ Ссылка ]
Update April '21 The ring no. 12 in the cylinder can be source here: [ Ссылка ]

#TriumphStag #PowerSteering #Rack
#Triumph
#Stag
#power
#steering
#Adwest

свернуть