Check your date & get more rental info at the link below:
➨ [ Ссылка ]
How to setup wedding monogram lighting rentals with custom gobo
Setup name monogram with optional stand/plunger (helps elevate fixture to cover more space & control beams)
1.) Widen the tripod stand by loosening the side knob and pulling the legs out to form a wider base.
2.) Once you have the legs pulled to the right width (approximately 2 feet), then you can re-tighten the bolt (don’t over-tighten)
3.) Attach the plunger by sliding it over top of the light stand (it should be a tight fit)
4.) To attach the light you unscrew the top nut, slide the lighting bracket on the screw, and screw the nut back on (sandwiches the bracket in-between the two nuts)
5.) Plug the wedding name monogram into with power cord between the fixture and outlet
6.) Fixture will automatically turn on, slide barn doors painted red from the side of the fixture outwards, this makes the beam shine through the barrel
7.) Elevate the stand if necessary and aim your name monogram in the desired position (use the side bracket to adjust the angle)
8.) Use the green nobs on the fixture to adjust the zoom and focus (might take a minute to get in the best position)
Setup wedding monogram lighting on the table (no stand or plunger)
1.) Plug the wedding name monogram into with power cord between the fixture and the outlet
2.) Fixture will automatically turn on, slide barn doors painted red from the side of the fixture outwards, this makes the beam shine through the barrel
3.) Place the fixture either on the floor table and aim your name monogram in the desired position (use the side bracket to adjust the angle/elevation)
4.) Use the green nobs on the fixture to adjust the zoom and focus (might take a minute to get in the best position)
Ещё видео!