Full run-through of a test of LinuxCNC Pull Request 2562: Use G38.3 in qt_auto_probe_tool.ngc to be able to check probe status.
The verdict was delivered the day after the code was merged -- which is my bad for taking so long to edit this video. The Pull Request does the opposite of what is intended by switching from G38.2 to G38.3 it suppresses probe status messages.
00:00 Start
00:07 Part 1: Setup for using M6 remap code
00:59 Part 1, Step 1: Home
01:14 Part 1, Step 2: Tool Table Setup
01:47 Part 1, Step 3: Measure Tool-Setter Height
03:27 Part 1, Step 4: Position to Start Location
04:28 Part 1, Step 5: Set Working Coordinate System
05:17 Part 2: Test #1 of No Mod, No Errors
08:16 Part 2: Test #2 of Yes Mod, No Errors
12:27 Part 2: Test #3 of No Mod, Yes Errors
17:04 Part 2: Test #4 of Yes Mod, Yes Errors
18:10 Conclusion
19:03 Thank You
