Connecting your Ruida-powered laser to Lightburn over Ethernet is easier than you think. It takes just a few minutes, and you'll be up and running in no time at all.

Windows command: ipconfig
macOS command: ifconfig

You're looking for the IP address of the Ethernet port as well as the subnet mask/gateway, both of which are required to connect your laser to Lightburn. Take the IP address, offset it by one (I went from .39 to .40), and enter that address (and the exact subnet mask) into the laser. In Lightburn, simply enter the IP address you put into the laser, and you'll be ready to go!
~~~~~~~~~~~~~~~~Chapters~~~~~~~~~~~~~~~~

00:00 - Intro

00:49 - Getting the IP in Windows

01:22 - Entering the IP and subnet into the laser

02:22 - Configuring Lightburn

02:56 - Outro

~~~~~~~~~~~~~~~~Links~~~~~~~~~~~~~~~~

Use code CREATEDWORKSHOP for 10% off at Monport

Monport 80W CO2 Laser Engraver - [ Ссылка ]

Calipers - [ Ссылка ]

Exhaust fan kit - [ Ссылка ]

6-inch Duct Hose [ Ссылка ]

Lightburn - [ Ссылка ]

Creative Fabrica - [ Ссылка ]

~~~~~~~~~~~~~~~~Camera gear~~~~~~~~~~~~~~~~

Body: Sony a6500 [ Ссылка ]

Body 2: Sony a6000 [ Ссылка ]

Main lens: Sony 18-105mm f/4 [ Ссылка ]

Secondary lens: Tamron 28-75 f/2.8 [ Ссылка ]

~~~~~~~~~~~~~~~~Store~~~~~~~~~~~~~~~~

Check out my store to support Created Workshop! [ Ссылка ]

~~~~~~~~~~~~~~~~Social links~~~~~~~~~~~~~~~~

Be sure to follow me across social media to stay up-to-date on the latest projects at Created Workshop!

[ Ссылка ]

[ Ссылка ]

[ Ссылка ]

~~~~~~~~~~~~~~~~Affiliate disclosure~~~~~~~~~~~~~~~~

Some of the links above are affiliate links and Created Workshop could earn a small percentage of revenue from your purchase through them. There is no additional charge for you to use these links, but it does go a long way to support our content.

свернуть