so my laser kept shutting off while i was working on a job
iv been Turning the scan angle to 180°
which would then start the job again from the top of the work piece,
then you would have to stop the laser at the exact point to where is previously stopped,
with this method, if the laser ever shuts fine again take note of the time ended,
pop to the preview and set the slider to the time ended shown in the console tab,
press start from here and the laser will automatically start from the point where it did previously stop!
thanks guys
![](https://i.ytimg.com/vi/Ume_ZUARbv8/maxresdefault.jpg)