This DIY wingback armchair frame was built using scrap wood and upholstery was done with piping along the back of the wings and sides at the front.

Supplies:
6x1(150mmX25mm) For the wings
5x1(125mmX25mm) for the Armrests
2x1(50mmX25mm) for the arm structure
For the base I used chipboard from an old wardrobe, this should be cut to the size you want your armchair to be
For the rest of the wood I cut 4x1(100mmX25mm) into strips, 3 or 4 strips is fine, these do not need to be exact - These are for the back supports and optionally the arm structure, make the sides and top of the back wider, between 2"(50mm) and 3"(75mm)
Wooden legs - Choose the style you prefer (I used leg plates screwed to the bottom of the chair to easily screw the legs into
Foam

NOTE: The foam density should be based on your preference

1 sheet 70"x20" @ 2 inch thick High density
1 block 20"x20" @ 3 inch thick Medium density
2 sheets 70"x20" @ half inch thick Low density

FULL BUILD GUIDE available here - [ Ссылка ]

Please like, comment and subscribe to see more like this
Subscribe: [ Ссылка ]

свернуть