WARNING:
DO NOT SET VALVE TO A, B, C, or VERY HOT!
Honeywell Valve has detected a“water too hot” event, the gas valve will never work again — unless you know how to reset "it", the HONEYWELL FRANKENVALVE! Here is the simple fix. I opened the cover again, left everything plugged in, took a piece of speaker wire with the plastic off of the ends, and held the wire ends to the top left pin and the top-right pin for a few seconds. I saw that the light went out and the pilot had gone out. I closed the cover again and lit the pilot again. Now the light changed from flashing 4 times to flashing 7 times. This time I left the knob in the pilot position for 10 minutes. When I came back to check the water heater, I saw that the light was flashing normally. I turned the knob to just the Hot setting and it fired up! MY CHOICE / NOW, WHAT'S YOURS? Please Subscribe, Like, and Share my Videos.

#GasWaterHeater #Honeywell #WaterHeaterValve

Gas Water Heater:


Links: [ Ссылка ]


Do the valves look about right? On the 40 & 50 gal Heaters Below?

40 gal. Residential Gas Water:
[ Ссылка ]

50 gal. Residential Gas Water:
[ Ссылка ]


Water Heater Control Valve :

[ Ссылка ]

[ Ссылка ]

[ Ссылка ]

[ Ссылка ]

[ Ссылка ]

[ Ссылка ]

[ Ссылка ]

[ Ссылка ]

📊 Robinhood Free Stock:
[ Ссылка ]

📉 Webull Free Stock:
[ Ссылка ]

📈 Acorns:
[ Ссылка ]

Disclaimers: all opinions are my own, sponsors are acknowledged. Links in the description are typically affiliate links that let you help support the channel at no extra cost.

свернуть