This video goes over the steps for install an EAG Tailgate Table on a 2012 Jeep Wrangler JK Unlimited. Even if you have a different year or model Wrangler ( JL TJ ect), the installation should be the same. Unfortunately there were technical difficulties and some audio (as I am sure you will notice, LOL) and video was lost. I don't have the step where you will need to drill into your tailgate, so the nutserts have somewhere to go. It is a pretty simple process. Hold up the tailgate bracket, or better yet have a buddy hold it up, and use a sharpie to mark where the holes will go. Then use a punch to tap in a divot, so your drill bit has a place to start. That is about it. Just make sure the holes are cleaned up, so the nutserts are able to slip in. Also try to keep your wholes as tight as possible, just big enough for the nutsert to be pushed in. You will notice that the bottom 2 holes lineup with vents on the tailgate. Due to this I opted to just leave those nuts out. I wanted to wait and see how the 4 bolts would do, if I noticed any issues I would drill new holes through the bracket, but to date, everything has held up well.
The install overall was fairly simple and straightforward. You should not be afraid to tackle this project on your own. I have so far been very happy with the EAG table. Yes I had to upgrade the hardware, but everything else has stayed tight with no issues...and most importantly, no rattling. I would buy it again, especially for the price point. Hope you found this video helpful and if you have any questions, please leave them below.
![](https://i.ytimg.com/vi/VeNzqMUcOrE/maxresdefault.jpg)