This video will show you how to set up your radio to work with dRehmFlight VTOL. The code supports PWM, PPM, SBUS, and DSM type receivers, allowing you to connect and use 6 channels within the default code. Code is accessed and modified within the Arduino IDE with the Teensyduino add-on.
*What is dRehmFlight VTOL?:* [ Ссылка ]
*Download the Code and Documentation:* [ Ссылка ]
*RcGroups Support Thread:* [ Ссылка ]
Arduino Download: [ Ссылка ]
Teensyduino Add-on: [ Ссылка ]
Setting up your radio with dRehmFlight VTOL is a simple process that only requires minor setup within the code and within your radio's built-in functionality. After binding your transmitter to your receiver and plugging the receiver in to the Teensy, the full setup process will not take more than 10 minutes.
NOTE: This video is dated and does not include instructions for newly supported Spektrum DSM satellite receivers. DSM receivers should be connected to RX3 (pin 15) and powered from a 3.3V pin on the teensy.
#dRehmFlight #VTOL #FlightController
Setting Up Your Radio Connection - dRehmFlight VTOL
Теги
dRehmFlightVTOLflight controllerarduino flight controllerteensy flight controllerdrone flight controllermultirotor stabilizationrc airplane stabilizationrc airplane flight controllerDIY flight controllerarduino flying projecthow to build flight controllerhow to make a flight controllerdRehmFlight tutorialteensyduinoTeensy 4.0radio calibrationdrone radio controllerbetaflight radio setupradio controlhow to make a dronehow to build a drone
