Setting the address number of a Cobalt Digital Point motor is the same regardless of DCC control system being used. There are no special tricks - this video explains the simple process that is the only way to set the addresses. It couldn't be simpler!
1) Put the Cobalt iP Digital Point Motor into 'set' mode
2) Send the command to change the point as if you are operating it
3) Put the Cobalt iP Digital Point Motor into 'run' mode
4) You are now done!
DO NOT USE THE PROGRAMMING TRACK OR IT WILL NOT WORK!
For more information see our website at [ Ссылка ]
Music: Bensound.com
Ещё видео!