This is a detailed video in which we install the correct ignition components in our 1975 project 280SL. The ignition control module and coil are removed from our rusty 1975 450SL parts car. New ballast resistors are installed along with stainless steel hardware. There is still a ton of work to do before we get this car running, but we are making good progress.

0:00 Intro
2:43 Remove ignition control unit from parts car
4:46 Ignition control unit part number Bosch 0227051017
4:58 Remove rusty case from control unit using induction torch
6:50 Fabricate a new ignition box cover
8:46 Paint with Eastwood rust encapsulator and Chassis Black
9:05 Stainless steel screws from ACCU
9:40 New ballast resistors from Parts in Motion
10:48 Check drain hole is not blocked before installation
11:38 Test ignition coil and replace with correct coil from parts car
13:20 Check ignition coil earth
13:30 Attach new ballast resistors to inner fender
13:53 Refurbish/paint ignition coil and replace fitting with stainless steel
14:30 Tech specs of blue coil according to service manual
15:25 Connect ignition control module wiring
16.30 Starter motor wiring+neutral safety switch

свернуть