Just a short video showing the outlining steps to make a carriage lock for your mini lathe. One thing that I did not note in the video was about the bolt hole for the locking bolt. I drilled the hole fully through with a regular drill bit. But in order to get a nice flat bottom counter bore for the bolt, I used an endmill on the drill press to bore down the depth I needed. Any questions or comments please leave below.
7x12 lathe [ Ссылка ]
This is a Amazon affiliate link. A small commission will be paid if you use this link to purchase but does not effect your cost.
![](https://i.ytimg.com/vi/YHAZL1UHJrc/mqdefault.jpg)