20 QT Stand Mixer

Assembly and Operating Procedures

*No assembly needed *
-Insert the knob on the back of the bowl into the hole on the unit.
-Raise bowl with crank on side of unit when ready to mix, lower bowl when done.
-Select appropriate speed.

Disassembly and clean up
-Remove paddle or whip.
-Lower bowl and tilt the front edge up to disengage the knob from the hole.
-Jeff cleans bowl and paddle/whip.
-Clean table and whole machine paying special attention to shaft where the paddle/whip attaches.

Notes
-Hobart has a timer; make sure it is off/hold.
-Use paddle when not much air in needed to be incorporated.
-Use whip attachment to add lots of air; can be used with cream cheese or butter only if softened to room temperature.
-Motor must be all the way off before changing speeds

свернуть