Engine Shutoff Solenoid failed and the engine would not stop. If one is careful, you can manually push in the plunger. HOWEVER, after the engine stops, if the plunger is binding, be sure to PULL the plunger back out, or the engine might not start, might not run well or cause other operation issues.

@ 2:95 and at 3:40 In the video I said it shut off the air... realized later, it is FUEL. This is my first and only diesel engine, and I am just learning as I go.

This solenoid was cleaned after 2700 hours of use. The binding probably caused the fuse to blow? I do not know, but we shall see how long after October 31 /2021, this solenoid continues its job. April /2024.... still original solenoid, though I have two backup solenoids off Amazon. I could probably pull the rubber boots off one of the new ones, if this solenoid keeps working?

DO NOT install a heavier than 15 amp fuse, as it will burn out the solenoid, and at last check, replacement was around $120 from Kubota.

This video is another explanation on the BX24: [ Ссылка ]

свернуть