If you've purchased a reman Ford Powertrain Control Module (PCM) you may need to reprogram it before installing on the vehicle. This detailed video explains the steps required for proper installation.
NOTE: Replacement unit part numbers ending in "F" means the module must be Flash programmed with the correct calibration programmable parameters and VIN
**Make sure to have all tools needed to program including a PC with internet connection and a Ford approved J 2354 tool or Ford vehicle communications module (0:36)
**A subscription to the Ford module programming applications for the J 2354 tool or integrated diagnostic software is also need (0:42)
**We recommend connecting a battery charger to the vehicle during programming or learning procedures (0:57)
Was this video helpful. If so, make sure to like it, and be sure to subscribe to our channel.
For technical bulletins regarding steering visit any of our product pages on: [ Ссылка ]
Stay connected for more updates and tips:
- Facebook: [ Ссылка ]
- Twitter: [ Ссылка ]
- Instagram: [ Ссылка ]
- Website: [ Ссылка ]
**Disclaimer**
At CARDONE we cannot guarantee against improper interpretation or application of the information we present in this video. You should always follow the enclosed safety guidelines, consult your OE repair manual for correct specifications when performing any install or repair procedure. Any injury, damage or loss that may result from improper use of tools, equipment, or from the information contained in this video is the sole responsibility of the user, and not of CARDONE Industries.
