In this video I experiment with closing out the trim tab end with foam , resin, flox, and micro balloons. It actually wasn't to hard and I think came out pretty good.
Thanks to Stu's Aircraft Factory for the method:
[ Ссылка ]
Below are some affiliate links to some of the tools and consumables I have been using. I appreciate your support and feel free to leave questions and comments below.
Welder [ Ссылка ]
Measuring etc:
Machinist Square [ Ссылка ]
Combination Square [ Ссылка ]
Straight Edge [ Ссылка ]
Angle Finder [ Ссылка ]
Epoxy Resin work:
3M respirator mask [ Ссылка ]
Rubber Gloves [ Ссылка ]
Digital Scale [ Ссылка ]
Mixing cups set [ Ссылка ]
Self Etching Primer [ Ссылка ]
Sanding Block [ Ссылка ]
Rasp [ Ссылка ]
File Set [ Ссылка ]
Sanding Sponges [ Ссылка ]
West Systems Resin kit [ Ссылка ]
Electrical:
Magnifying Lamp [ Ссылка ]
Molex Micro-fit connectors [ Ссылка ]
Cable Snap Bushings [ Ссылка ]
Dupont crimp tool [ Ссылка ]
Helping Hands [ Ссылка ]
Misc:
Transfer Punches [ Ссылка ]
Torque Seal [ Ссылка ]
Hearing Protection [ Ссылка ]
Milwaukee Rivet Gun [ Ссылка ]
Ещё видео!