*Ignore the message at 2:18, Not sure how that got there but it was supposed to say "Note where the phase colored signal wires go as to not mix them up, It can become out of phase but typically will just operate in reverse operation."
Hello folks, 🔋BattTube here. Today we will be replacing the Hall Effect Sensors in a 48v 500w E-Bike Motor. The hall effect sensors in this motor are 41F's but go by several identities "41F/SS41F/S41/SH41/0H41". Only one was bad but it only made sense to replace all 3 seeing how cheap these are, Even paying $15 for 10 which are worth pennies in bulk. The Hall Sensors make use of the magnetic fields of the changing phases to determine RPM which can then be derived into speed.
👍🔔 Thanks For Watching! 🔔👍
Please Like and subscribe if you enjoyed it and click the bell icon to keep up to date with new uploads when they are released!
📰❤️Follow & Support❤️📰
Patreon - [ Ссылка ]
Utreon - [ Ссылка ]
Facebook - [ Ссылка ]
Discord - [ Ссылка ]
Rumble - [ Ссылка ]
💰🛒 Linked Products 🛒💰
*Amazon affiliate links
10x Bestol SS41F 41F/0H41/SH41/S41 Bipolar Hall Effect Position Sensors:
CAN - [ Ссылка ]
US - [ Ссылка ]
💰🛒 Products I use 🛒💰
Lomvum 6000c Multimeter:
CAN - [ Ссылка ]
US - [ Ссылка ]
Baku 601D Hot Air + Solder Station (Hako knockoff):
CAN - [ Ссылка ]
US - [ Ссылка ]
CHEAP PCB Spot Welder:
CAN - [ Ссылка ]
US - [ Ссылка ]
Sunkko 788H Spot Welder:
CAN - [ Ссылка ]
US - [ Ссылка ]
Wire Strippers:
CAN - [ Ссылка ]
US - [ Ссылка ]
Mic - Blue Snowball:
US - [ Ссылка ]
CAN - [ Ссылка ]
💡💭 If you have any suggestions or ideas for future videos please be sure to leave them in the comments section below! Thank you. 💭💡
Chapters:
Intro & Motor explaination. - 0:00
Shroud Removal. - 1:12
A look inside & What is a hall sensor? - 2:05
Removing the old hall sensors. - 3:09
Prepping for the new sensors. - 8:36
Soldering the new sensors. - 16:37
Soldering timelapse. - 21:03
Installing the hall effect sensors! - 24:17
Securing the wires - 26:57
Installing the motor shroud - 29:40
Ещё видео!