▼Parts and Tools Listed Below▼
How to replace the rear valve block on a range rover sport or LR3. The rear valve block electronically controlled air supple to the rear left and right air springs, and also allows air to equalize between the springs or vent out of the springs. Problems with the rear valve block leaking can cause dropping of the rear end of the vehicle when left for extended periods.

This video will walk through the function of the rear valve block as well as how to access and
remove/replace the valve block. A future video will detail how to clean the valve block.

Video of teardown and cleaning of valve blocks: [ Ссылка ]

Parts required:
Replacement valve block: [ Ссылка ]

Tools required:
13mm socket or wrench (for battery terminal)
12mm wrench (for voss connectors)

Tool set I use that contains all above tools: [ Ссылка ]

Works with RRS or LR3 MY 2005, 2006, 2007, 2008, 2009

#rangeroversport #LR3 #rangerover #landrover

Disclaimer:
Due to factors beyond my control, I cannot guarantee against improper use or unauthorized modifications of this information. I (Hazy) assume no liability for property damage or injury incurred as a result of any of the information contained in this video. Use this information at your own risk. I (Hazy) recommend safe practices when working on vehicles and/or with tools seen or implied in this video. Due to factors beyond my control, no information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. Any injury, damage, or loss that may result from improper use of these tools, equipment, or from the information contained in this video is the sole responsibility of the user and not Hazy.

On My Way by Ghostrifter Official | [ Ссылка ]
Music promoted by [ Ссылка ]
Creative Commons / Attribution-ShareAlike 3.0 Unported (CC BY-SA 3.0)
[ Ссылка ]

свернуть