This is a complete install installation for the Wham Bam Flexible Build System, shown here on a CR-10 V3, although it is a similar process for most machines.

In this video we mount the Magnetic Base directly to the heated bed, if you would like to mount to a separate build surface such as glass or aluminum and use bed clips to keep it in place, you can refer to this video: [ Ссылка ]

We also show the preparation of our Pre-Installed Flexi Plate with PEX, if you would like to see how to install PEX on a Flexi Plate watch this video: [ Ссылка ]

Our bed leveling G-codes can be found here: [ Ссылка ]

For a more detailed video on bed leveling and getting a great first layer: [ Ссылка ]

This video is full of important tips and insights, here is an index if you would like to jump around to different sections:
0:00 Introduction
00:32 Install on Build Surface or Heated Bed
01:12 Verifying Build Surface Flatness
04:22 Accounting for Change in Z Height
16:30 Cleaning and Preparing your Heated Bed
22:25 How to Measure your Heated Bed for the Right Kit
23:00 Installing Magnetic Base to Heated Bed
27:00 Preparing your PEX or Build Surface
31:03 Verifying home after the install
33:20 Bed Leveling
40:00 First Print

We hope you find this helpful, and if so, please do let us know in the comments!

Where to find us online:
[ Ссылка ]
[ Ссылка ]
[ Ссылка ]
[ Ссылка ]
[ Ссылка ]
[ Ссылка ]
[ Ссылка ]
[ Ссылка ]

свернуть