How to repair the Storm Launcher Tail/Stabilizer foam

Sorry for the bad audio.

Anyways all you need is foam board I used Elmers which has a thickness of 3/16" or 5mm.

Completely remove the broke fin from you Storm Launcher

Once removed take an xacto or hobby knife and start removing the foam fins from the styrofoam fuselage. The slot cut into the fuseloge is about 1/2 deep and all the pieces of the broken fin need to be removed. Needle nose pliers are handy when removing the glued pieces.

Once that is done take your old fin/stabilizer/tail and tape it the the new foam board

Trace all around it using a pen be sure to mark where the fold lines are.

Once that is done remove the old fin.

Leave an extra 1/2" or so on the ends so that the new fin can be pressed into the Storm Launcher.

My fin stays in without glue or tape. When my Storm Launcher crashes it will just pop off which is good.

Questions? just ask or let me know about your modifications or repairs!

свернуть