Additional Tricks and Tips for cutting Cast Acrylic on a 3018 CNC. We review Type of Acrylic, the tape method, Job Start & Zed Paper Method, Should you keep the paper on your acrylic (Hint, No), & Clean Up.
Remember Cast Acrylic has a higher melting point than Extruded Acrylic. While I have no issues Engraving or Doing the Detail work on Extruded, you will need to find a cooling method to cut it, such as the Water, Soap, and Hot Glue Method, but that is for a different video.
For homing the Z or ZED axis with the paper method, I go down an extra 0.1mm to 0.3mm depending on material I am cutting. For Cast Acrylic I go down an extra 0.2mm normally once the paper catches.
For the tape method you can use Painters Tape and even Double sided Carpet Tape. As for Glue I use Super Glue, but there are several options out there that you can use.
Check out my first Acrylic Cutting video: [ Ссылка ]
#cnc #maker #edgelit #acrylic
YOU CAN GET THE NEW MK2 LONG MILL HERE (These are affiliate links that help support the channel and add nothing to the overall cost):
[ Ссылка ]
The Below Links are affiliate links and I may make a commission off of any items sold. This helps fund the channel and to keep making videos.
LINKS TO MATERIALS I USE:
Link to the .1mm V bit:
[ Ссылка ]
Link to the .8mm-3mm End Mills:
[ Ссылка ]
90 Drag Bit:
[ Ссылка ]
CAST Acrylic
[ Ссылка ]
LED BASE:
[ Ссылка ]
TAPE:
[ Ссылка ]
GLUE:
[ Ссылка ] OR [ Ссылка ]
![](https://i.ytimg.com/vi/aoNXvPiZFug/maxresdefault.jpg)