Hey Guys,
I was replacing the sprockets and chain of my Honda CT110 today, and was surprised to see the old front sprocket was kinda loose/wobbling. I thought it would be ok after installing the new sprocket, but that's not the case.
The video above was taken after installing the new sprocket and tightening the holding bolts properly.
So, is this normal? Or is the holding clip is worn out/too thin??!!!
The holding clip & bolts are old ones. The new sprocket didn't come with a new holding clip & bolts.
The reason for replacing the sprockets & chain is 'cos few months back I went down the tightarse way & replaced the rear worn out sprocket on it's own without replacing the chain. Within couple of months the rear sprocket wore out and teeth were deformed and pointing forward, so I had to replace sprockets & chain in one go.
I tightened up the loosening chain from the worn out rear sprocket for few weeks, so I'm not sure whether that caused some damage to the output shaft from the gearbox?!! Probably not.
Thanx
