How to drain geyser (part 1) - [ Ссылка ]
Before watching this video watch part 1 link above
This video is about changing the bad element or cleaning the geyser tank .
You carefully remove the electric connections to the element then to uninstall the element open 3 nuts then simply pull down the gasket and the geyser element.
Once the geyser element is removed you can then clean the chlorine deposit in the tank and if your element is bad then brought a new one same as the old one. then simply insert the new element and tight the 3 nuts and put back all the connections.
Tools used
- Pliers ( buy link - [ Ссылка ] ) (affiliate)
- Screwdriver ( BUY LINK - [ Ссылка ] )
- Socket 11 mm
- SPANNER ( BUY LINK - [ Ссылка ] )

SOCKET SET buy link - [ Ссылка ] (affiliate)

MY GADGET AND YOUTUBE EQUIPMENT'S
- MOBILE - GLAXY GRAND 2
- TRIPOD ( BUY LINK - [ Ссылка ] )
- LOW BUDGET TRIPOD ( BUY LINK - [ Ссылка ] )
- MOBILE HOLDER ( BUY LINK - [ Ссылка ] )
- BEST MICROPHONE ( BUY LINK - [ Ссылка ] )
- ANOTHER GOOD MIC ( BUY LINK - [ Ссылка ] )
- LOW BUDGET MIC ( BUY LINK - [ Ссылка ] )
- TRIPOD WITH MOBILE HOLDER AND MIC COMBO ( BUY LINK - [ Ссылка ] )

Hope this video is helpful for you
Thank you for watching

MORE VIDEOS
how to change clutch cable - [ Ссылка ]
Geyser thermostat repair - [ Ссылка ]
Self start relay check - [ Ссылка ]
Car service at home - [ Ссылка ]
Dead battery repair/recover - [ Ссылка ]
How to test geyser element if its good or bad - [ Ссылка ]

свернуть