This benchy, printed with Marlin, matches the Klipper record time for the Benchy.
Configuration.h is tweaked for speed and some M20* commands + M220 are used with extreme high values. In Cura extension "Printer Settings" is used to set very high X Y Z speeds allowing some very high print speed settings. Faster is possible but requires changing the upper limits defined in the Marlin code. After changing the Marlin code (maximum feedrate increased from 999 to 9999) I even managed 02:08 . The simulator runs in "Realtime" mode.
00:27 Start extruder heating
01:48 Start print
04:13 Finish print
The Marlin Simulator: [ Ссылка ]
Sound: 3D.Printer by Lartti on FreeSound.org
![](https://i.ytimg.com/vi/cmFVQZX44UM/maxresdefault.jpg)