In this video I show how to splice a locking loop into 12 strand: Spreta, Dyneema, or Vectran. This splice only requires access to one end of the rope but will not allow you to splice blocks or thumbnails into the eye. If you need to splice on a block use the locking eye splice: [ Ссылка ].
This was a video by the Splicing Guru, make sure you get subscribed for easy access to these videos when you need them most. If there are any knots or splices you would like to learn how to do leave it in the comments and I will get a video up as fast as I can.
The tools I use to splice are:
Good Fids: [ Ссылка ]
Puller: [ Ссылка ]
Stainless Wire to use as a puller: [ Ссылка ]
Sharp Knife: [ Ссылка ]
Whipping Twine: [ Ссылка ]
Needles: [ Ссылка ]
Sharpie: [ Ссылка ]
Jet Lighter: [ Ссылка ]
Bag: [ Ссылка ]
