Youll find the cut list below to follow along with this gun concealment coffee table. I designed this coffee table since the others I have seen have a few obvious signs that something is off. Like holes in the apron for the drawer slides to move back and forth. So this one is designed with a sliding apron, that really quite effectively hides the fact that this is anything but a coffee table.
***If you want a deeper concealment area, use 2x6 instead of 2x4 for the aprons. This will give you 2 more inches of usable space.
Buy plans here: [ Ссылка ]
📝Cut list:
Table top: 45"x27"x3/4" (you can use a thicker table top if desired, just make changes to Magnet lock)
4x Legs 16" x 3" x 1.5"
1x Sliding Long Apron 38.5" x 3" x 1.5"
1x Fixed Long Apron 38.5" x 2 7/8" x 1.5"
2x Short Aprons 18" x 2 7/8" x 1.5"
2x Short Stretchers 18" x 1.5" x 1.5"
2x Long Stretchers 38.5" x 1.5" x 1.5"
2x Drawer Slide Pieces 20.5" x 1.5" x 1.5"
1x Bottom piece Length: Same as long apron Width: Must measure between fixed and sliding apron
🧰Hardware and tools used:
20" Drawer slides: [ Ссылка ]
Stainless steel spring loaded latch: [ Ссылка ]
Strong Magnet: [ Ссылка ]
Steel dowels: [ Ссылка ]
1/2" Forstner bit: [ Ссылка ]
RFID Lock: [ Ссылка ]
Massca Pro M2 pocket hole jig: [ Ссылка ]
2.5" pocket hole screws: [ Ссылка ]
Cuttable Kaizen Foam: [ Ссылка ]
Gun Stock Wood stain: [ Ссылка ]
Chapters:
00:00 Intro
00:48 Cut List and Wood Prep
02:25 Leg Assembly
03:17 Pre Sanding
03:40 Decorative Option In Legs
04:25 Installing Stretchers, Fixed Apron
04:47 Making Table Top
05:32 Staining
06:08 Installing Drawer Slides
07:05 Cutting, Installing Sliding Apron
08:00 Installing Spring Loaded Latch
08:58 Installing Magnet Latch
10:17 Installing RFID Lock
11:05 Cutting, Installing Bottom Piece
12:07 Cutting Manual Latch Access Hole
12:21 Finish Up Magnet Latch
13:29 All done, Other cool things
Ещё видео!