How to set the cable length for manual hub Interfaces.
00:04 - For this, you need the following tools:
Ruler
2mm Allen wrench
cutting pliers
00:08 - Start by turning the controller on the handlebar counterclockwise to set it to the full overdrive position.
00:15 - Guide the cables through the cable housing.
00:21 - Make sure the cable housing is fully seated in the barrel adjusters, and turn both barrel adjusters in all the way.
00:29 - The longer cable is the underdrive cable.
00:35 - Slide the cable through the underdrive cable stop.
Mount the cable stop at 120 mm from the end of the cable housing, and tighten it to 1.5 to 2 Newton meters.
00:54 - Pull the overdrive cable out, setting the controller into full underdrive.
01:00 - Slide the overdrive cable through the cable latch, set this at 114mm from the cable housing and tighten it to 1.5 to 2 Newton meters.
01:15 - Cut the underdrive cable as short as possible.
Cut the overdrive cable at the mark and tuck the remaining cable length in the pocket underneath.
01:29 - Learn more about How to set the cable length for manual hub Interfaces at [ Ссылка ]
Ещё видео!